//*****************************************************************************
//
// pinout.h - Prototype for the function to configure the device pins on the
//            EK-TM4C1294XL.
//
// Copyright (c) 2013-2017 Texas Instruments Incorporated.  All rights reserved.
// Software License Agreement
// 
// Texas Instruments (TI) is supplying this software for use solely and
// exclusively on TI's microcontroller products. The software is owned by
// TI and/or its suppliers, and is protected under applicable copyright
// laws. You may not combine this software with "viral" open-source
// software in order to form a larger program.
// 
// THIS SOFTWARE IS PROVIDED "AS IS" AND WITH ALL FAULTS.
// NO WARRANTIES, WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING, BUT
// NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
// A PARTICULAR PURPOSE APPLY TO THIS SOFTWARE. TI SHALL NOT, UNDER ANY
// CIRCUMSTANCES, BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
// DAMAGES, FOR ANY REASON WHATSOEVER.
// 
// This is part of revision 2.1.4.178 of the EK-TM4C1294XL Firmware Package.
//
//*****************************************************************************

#ifndef __DRIVERS_PINOUT_H__
#define __DRIVERS_PINOUT_H__

//*****************************************************************************
//
// If building with a C++ compiler, make all of the definitions in this header
// have a C binding.
//
//*****************************************************************************
#ifdef __cplusplus
extern "C"
{
#endif

//*****************************************************************************
//
// Define Board LED's
//
//*****************************************************************************
#define CLP_D1              1
#define CLP_D2              2
#define CLP_D3              4
#define CLP_D4              8

#define CLP_D1_PORT         GPIO_PORTN_BASE
#define CLP_D1_PIN          GPIO_PIN_1

#define CLP_D2_PORT         GPIO_PORTN_BASE
#define CLP_D2_PIN          GPIO_PIN_0

#define CLP_D3_PORT         GPIO_PORTF_BASE
#define CLP_D3_PIN          GPIO_PIN_4

#define CLP_D4_PORT         GPIO_PORTF_BASE
#define CLP_D4_PIN          GPIO_PIN_0

//*****************************************************************************
//
// Prototypes.
//
//*****************************************************************************
extern void PinoutSet(bool bEthernet, bool bUSB);
extern void LEDWrite(uint32_t ui32LEDMask, uint32_t ui32LEDValue);
extern void LEDRead(uint32_t *pui32LEDValue);

//*****************************************************************************
//
// Mark the end of the C bindings section for C++ compilers.
//
//*****************************************************************************
#ifdef __cplusplus
}
#endif

#endif // __DRIVERS_PINOUT_H__