2025-06-08 22:33:35 +02:00

111 lines
3.9 KiB
C

//*****************************************************************************
//
// buttons.h - Prototypes for the evaluation board buttons driver.
//
// Copyright (c) 2013-2017 Texas Instruments Incorporated. All rights reserved.
// Software License Agreement
//
// Texas Instruments (TI) is supplying this software for use solely and
// exclusively on TI's microcontroller products. The software is owned by
// TI and/or its suppliers, and is protected under applicable copyright
// laws. You may not combine this software with "viral" open-source
// software in order to form a larger program.
//
// THIS SOFTWARE IS PROVIDED "AS IS" AND WITH ALL FAULTS.
// NO WARRANTIES, WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING, BUT
// NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
// A PARTICULAR PURPOSE APPLY TO THIS SOFTWARE. TI SHALL NOT, UNDER ANY
// CIRCUMSTANCES, BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
// DAMAGES, FOR ANY REASON WHATSOEVER.
//
// This is part of revision 2.1.4.178 of the EK-TM4C1294XL Firmware Package.
//
//*****************************************************************************
#ifndef __BUTTONS_H__
#define __BUTTONS_H__
//*****************************************************************************
//
// If building with a C++ compiler, make all of the definitions in this header
// have a C binding.
//
//*****************************************************************************
#ifdef __cplusplus
extern "C"
{
#endif
//*****************************************************************************
//
// Defines for the hardware resources used by the pushbuttons.
//
// The switches are on the following ports/pins:
//
// PJ0 - Left Button
// PJ1 - Right Button
//
// The switches tie the GPIO to ground, so the GPIOs need to be configured
// with pull-ups, and a value of 0 means the switch is pressed.
//
//*****************************************************************************
#define BUTTONS_GPIO_PERIPH SYSCTL_PERIPH_GPIOJ
#define BUTTONS_GPIO_BASE GPIO_PORTJ_BASE
#define NUM_BUTTONS 2
#define USR_SW1 GPIO_PIN_0
#define USR_SW2 GPIO_PIN_1
#define LEFT_BUTTON USR_SW1
#define RIGHT_BUTTON USR_SW2
#define ALL_BUTTONS (USR_SW1 | USR_SW2)
//*****************************************************************************
//
// Useful macros for detecting button events.
//
//*****************************************************************************
#define BUTTON_PRESSED(button, buttons, changed) \
(((button) & (changed)) && ((button) & (buttons)))
#define BUTTON_RELEASED(button, buttons, changed) \
(((button) & (changed)) && !((button) & (buttons)))
//*****************************************************************************
//
// If building with a C++ compiler, make all of the definitions in this header
// have a C binding.
//
//*****************************************************************************
#ifdef __cplusplus
extern "C"
{
#endif
//*****************************************************************************
//
// Functions exported from buttons.c
//
//*****************************************************************************
extern void ButtonsInit(void);
extern uint8_t ButtonsPoll(uint8_t *pui8Delta,
uint8_t *pui8Raw);
//*****************************************************************************
//
// Mark the end of the C bindings section for C++ compilers.
//
//*****************************************************************************
#ifdef __cplusplus
}
#endif
//*****************************************************************************
//
// Prototypes for the globals exported by this driver.
//
//*****************************************************************************
#endif // __BUTTONS_H__